The basement waterproofing systems and their working

To answer that question, let’s first look at historically conventional basement waterproofing and how it is supposed to work. If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens: In case you are curious to know how the basement is built, you will see that the idea was first conceived in the design and then the next steps follow. It starts with the digging of a big hole, then the footer or foundations are laid. After the base is done, the walls of the basement are built and then only the rest of the house is constructed.

The important point to note is the first one in the list above – that big hole in the ground. When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. Loose backfill is what is used to fill this void. No matter how well the backfill is compacted, it is still backfill and water seeks the places of little resistance.

Water will constantly ooze into this area. Sometimes, creating a problem is the drainpipe that gets full of silt contained in most basement waterproofing systems. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. Allowing these pipes to fill up, can result in an overload of the system, which can be catastrophic to the basement’s outside walls.  Water will work its way through even the smallest gaps, even though basement walls are waterproofed in some way.

This type of problem doesn’t usually go away because the pipes that are supposed to take away the excess water gradually worsen over time. Many times there is simply no access to these pipes which is a huge oversight. Basement waterproofing is also applied to the external walls of the basement to try and keep the water out. This is also called a tanked system.

If you want to find out if you have water inside the concrete block of your walls simply tap a hole into the concrete block, near the floor, and see if you have water coming out of this block then you may want to consider a drained cavity waterproofing system this system drains the water from your walls, much the same way you just did, by adding drain holes in the bottom blocks that allows those areas to drain into a type of interior french drain system. To move water away from your property; it first must be collected and sent through drainage channels to a sump pump or a natural drainage field.

Basement waterproofing systems are superior because they are installed internally, have easy access ports for removing silt, and can be installed in basements where other methods have failed. In conclusion, you want a basement waterproofing system that will deliver:- a permanent or long term fix-stop water through the floor and walls- not disturb landscaping, decks, patios, driveways, etc- usually be an approved waterproofing method for home loans- often be substantially cheaper than other waterproofing methods.

You want to be sure to choose a reliable waterproofer for your home, keep in mind that it will greatly increase the value by far more than what you initally paid. You should look at waterproofing not as an expense but as an investment in the value of your home. Make it easier to start using basement waterproofing systems, quickly & easily. Learn the essential steps and get a problem-free environment with minimal outlay by visiting a basement waterproofing systems website. As with most companies you can now get information on basement waterproofing systems via an online website.

Leave a Reply

Your email address will not be published. Required fields are marked *